Inst. Manual and Warranty

The Star 100 Installation Manual and Warranty (read these instructions completely, prior to installing cover) IAPMO Rated: Complies with the ASME/ANSI Al12.19.8 (2005) at 80 Gallons Per Minute at a Safe Flow Rate Of 1.2 Feet Per Second
Recommended Single/Multiple Drain Application With use from 1 inch to 10 inch suction outlets
This Part was installed on:____________________by_____________________
Date	Mechanic/Company

Installation Tools Required: Phillips head screw driver. Awl. Cordless Drill. 1/16" drill bit.

1. Be certain pool pump motor is off and secured

2. Remove old drain cover

3. Inspect existing pool sump for damaged screw inserts or debris in the openings.
Replace Mud ring if necessary (attach new mud ring securely to the sump).
Clean all debris from screw inserts openings.

4. Insure mud ring (if applicable) is attached to the existing sump securely.

5. NOTE: It is imperative the Star 100 Anti-Entrapment Cover is securely
attached to the existing main drain sump. Prior to using any aquatic facility, inspection
of fasteners and observation for damaged/tampered with suction fittings is required.

6. Do not exceed safe flow rate by increasing pump horsepower. Follow manufacturer’s recommendations.

7. Install using supplied Stainless Steel screws and washers or obtain 316 Grade Stainless
Steel screws from a pool supply outlet.

8. NOTE: Only use 316 Grade SIS or equivalent in installing the Star 100.

9. The Star 100 can be installed in all Pools in a horizontal or vertical Plain.

10. If the sump you are attaching to has only two existing screw holes, drill two new screw
holes and install supplied screws through open slots.

NOTE: Do not over tighten screws. This may damage the Star 100 or cause the cover to sit
on the pool drain sump in a warped manner. The Star 100 is to be mounted in a “flush fit".
Insuring no gaps at outer edges. Keep these instructions for future reference.

Never operate pool without drain cover in place and properly affixed.
Death or Serious injury can result.

Part #: Star 100

NOTE: Anti-Entrapment cover must be replaced every 3 years.

Pool Drain/Suction Cover Plate. White with UV inhibitors.
For Technical Installation Assistance Call: 800-513-4372

Replace this part in three years from date of installation above.

Manufactured by: World Wide Sports, L.L.C.
112 South Hanley Road Suite 101
St. Louis, Mo. 63105
Technical Assistance: 800-513-4372